2068 ROUNDOVER & EDGE TRIM Multi Beading The strip of rubber on

The strip of rubber on the clamp face helps to reduce the chance of marring or slippage

Featuring a short down shear flute for a finished top edge

Reinforced brackets are pre-drilled for mounting to wall studs

Throat Depth: 1

Rollers are fitted with one way roller bearings to ensure each roller spins in the direction of the feed to prevent kickback

2068 ROUNDOVER & EDGE TRIM Multi Beading The strip of rubber on1 2"SH, 3 16"R, 1"LD, 1 2"SD Product Description Plunge Roundovers can cut a flat bottom while providing that traditional roundover edge. These bits can also be used to cut out your project, leaving only the traditional roundover edge on the side of your workpiece.