Universal Aluminum Bumper Vent Size:18" x 4.5" Has only been tested with

Has only been tested with 2012-2016 Bumpers

READ THIS BEFORE YOU ORDER - Bumper cover WILL NOT FIT over this bash bar  - If you need the bash bar to fit behind your bumper cover

* This bar is not intended for street use - off-road use only *

25x25mm bolts

On IS300/IS200 version - (4) 3/8" holes must be drilled in the pinch weld for the lower side of the mounting plates to be attached

Universal Aluminum Bumper Vent Size:18" x 4.5" Has only been tested withBumper vent panels are a great addition to cars with a rear diffuser or half cut rear bumper. These allow for air to pass through your bumper without getting trapped. FEATURES: Laser cut from . 063" aluminum Includes 1 8" aluminum rivets Includes inner sandwich ring to prevent rivets from pulling through plastic bumper TOOLS REQUIRED FOR INSTALLATION: Drill 1 8" drill bit Rivet install tool (1 8" rivets) Dremel or angle grinder with cutoff wheel Tape