CAN to TTL Serial Communication Module PC6-01 Pneumatic Push in Bowden Extruders for 3.0mm J-Head fitting The carbon brush design tolerates

The carbon brush design tolerates PWM control well with minimal noise generation

The ceramic construction provides superior frequency response characteristics with minimal parasitic inductance

These drivers accept logic-level step and direction signals from microcontroller GPIO pins and provide the necessary current amplification to drive the motor coils

Home Networking: Connect your PC

35C discharge rate ensures reliable power delivery under demanding flight conditions

CAN to TTL Serial Communication Module PC6-01 Pneumatic Push in Bowden Extruders for 3.0mm J-Head fitting The carbon brush design toleratesCAN to TTL Serial Communication Module CAN to TTL Serial Communication Module 3. 3V 5V This is an CAN to TTL Serial Communication Module. The module uses a black backplane high quality circuit board, Which Comes standard 3. 50mm Screw Terminal connector on the end, on the other end has a 5pin headers. There is a power light on the board to indicate the power supply status. The onboard voltage regulator chip supports 3. 3 5V wide voltage power supply.